777F Off-Highway Truck: Rear Suspension (Cylinder) Specifications

Part Number - 264-5810

S/N - -

Part Number - 264-5811

S/N - -

(1) Apply a coat of 4C-5593 Anti-Seize Compound to four pins prior to assembly with the bearing.

Outside diameter of pin ... 82.461 ± 0.025 mm (3.2465 ± 0.0010 inch)

Inside diameter of bearing ... 82.5373 ± 0.0127 mm (3.2495 ± 0.0005 inch)

Note: When you assemble the suspension cylinder, you must fill the cylinder with the proper amount of oil. Refer to the Testing and Adjusting, "Suspension Cylinder Oil Requirements" for the correct initial fill. See Testing and Adjusting, "Suspension Cylinder (Rear) - Purge and Charge" for the charging procedure and for the charging dimensions.

(A) Outside diameter of rod (over chrome) ... 228.52 ± 0.05 mm (8.997 ± 0.002 inch)

(B) Inside diameter of head (two places) ... 228.68 ± 0.03 mm (9.003 ± 0.001 inch)

(C) Inside diameter of cylinder ... 266.70 + 0.13 - 0.05 mm (10.500 + .005 - 0.002 inch)

(D) Outside diameter of rod (two places) ... 266.06 ± 0.13 mm (10.475 ± 0.005 inch)

(2) Lubricate the sealing lip lightly with the lubricant that is being sealed.

(3) Torque for one relief valve ... 50 ± 10 N·m (37 ± 7 lb ft)

The charging medium for suspension cylinder is dry nitrogen.

Internal volume ... 6.7 L (4013 in³)

Charged pressure ... 100 kPa (14.5 psi)

Service pressure ... 750 kPa (110 psi)

Bursting pressure ... 6100 kPa (885 psi)

Pressure Sensor (Payload Monitor)

Part Number - 221-3417
S/N - -

(1) Final installation torque for the pressure sensor group ... 45 ± 5 N·m (33 ± 4 lb ft)
Supply voltage ... 8 to 32 VDC
Frequency range ... 200.00 to 1602.56 Hz
Operating temperature ... -40 to 110 °C (-40 to 230 °F)
Note: The pressure sensor group may be installed 90 degrees in either directions from the vertical position. The port of the pressure sensor group should be pointed in the downward direction.

MARYGAR

777F Off-Highway Truck: Rear Suspension (Cylinder) Specifications 2012-12-02T11:09:00-08:00 Rating: 4.5 Diposkan Oleh: Unknown